I believe the airflow works just the same. The one I had was just the center bowl. It doesn't make an air tight seal when closed down to zero airports open. I use it set to one hole
This is correct about the xl fusions on my site. Just order the regular fusion and I will b substituting the xl bowls until the ones I have are gone. There's only a couple left until next order. Also I think it's a bit more than .14-.16 I'm getting closer to .14-.18 but that's a minut...
Absolutely bud. And as far as the new reddit goes I'm all about it. Same on the discord I just don't know how to set it all up. And with being the usa reseller I didn't think it would b right to be the mod on there
So I just tried something new with my fusion. I use the ronxs dual torch set on single flame with the center flame about 2 inches. Loosen the cap to where there is a bit of the tip showing. At a 90° angle aim the flame right into the gap. Put the tip of the center flame right up to the gap, rock...
I try to do what I can. I wasn't giving @Abysmal Vapor a hard time, i was trying to help him understand where bfg's mindset is. But that is what it is. I'm a vaporist first and foremost so I tend to fall on the side of how I would want to be treated but I also have to relay the message from bfg...
I believe this is more to get the silver back instead of just wasting it and leaving it on a broken cap. Plus, how can he fix a problem without actually seeing the product in his hands? Also, I'm sure u will b surprised to hear this, but there are people that will try to just get free stuff...
This definitely helps. But I just like everyone else sometimes forget because I'm baked. Lol.So we need a little help if we do forget. Yea, for sure always try not to tighten it down. This stops the problem from happening. A quick fix before the problem arises
You can also try adding some heat to it. I finally had one stick on mine. I couldn't break it loose by tapping it on the desk so I figured I would try to heat it up. I torched it for 5 seconds down near where the threads are on the inside. It loosened up right away without much effort at all...
I use the Firefox(2 inch center flame) and I aim the flame right between the airports on the cap and I angle the flame upwards to allow the center flame to stretch over the silver ring. It clicks at about 25 seconds and then I go like 4-5 seconds past the click for nice milky clouds on v3
The current stem is lined with metal and has a spiral intercooler as well. They are designed to fit the v3. I use mine on my v2 and it's a super tight fit( need tools to take apart) and thats with luring it up. There is a still difference in the od which makes the v2 too tight for the new wooden...
I have used the aomai single flame and they work but it does take a little longer. Maybe 40-45 seconds. The triple flame that comes in the dyna welcome kit works in about 30. And the jet flame(lol) that chillmike uses in his video is quicker but I can't say how much because I have not used one...
I heat mine at the bottom of the cap. Below the air holes and when it clicks its ready to go. Maybe a second or two at most and its ready to go. Ive been using a blazer single flame torch(it gives a little bit better aim) on about a 1.5 inch center flame
There is a quick vid on thedaniusa ig...