I use it and it works great. I set it at 625F and do a pre-heat in manual mode for 15 to 20 seconds and then heat again at same temp. till time-out. The second click of Thermocore happens just before Wand stops blinking the way I have it inserted in Wand which is with just a slight protrusion on...
Be patient. If you live in the States give it up to two weeks before it arrives. I've ordered two stems and the earliest arrival was 10 days from order date. It's worth the wait.
I'm about two weeks in now with the Convector XL and a little more with the 2nd Conductor (1st had display failure but quickly resolved by Camouflet) and consider both great 420 purchases. I'm amazed how quickly the Conductor heats up the Convector XL....crazy amount of power.
I've followed the...
I'm probably preaching to the choir here since I'm probably the only one who just recently (yesterday) joined the Vestratto Discord, but that seems to be where @Vestratto hangs out more so than here at FC and where I'm guessing breaking news about the Tornado will be found.....eventually cross...
This was my original thought but after reading about the 2.5Ah high output I went that route. The words '25% more power', 'compact' and 'runs 25% cooler' sold me.
XC POWER, COMPACT SIZE
Increased performance results in the same power as an M12™ REDLITHIUM™ XC3.0 battery in a 50% lighter...
I saw all those knockoffs yesterday when looking for a battery after I placed my order.......ended up getting (to start) one oem M12 2.5Ah high output battery and oem battery charger.......slightly over $50 US (don't know how amazon does it since same combo at Home Depot is $135).
Have you tried using the 0.2mm nozzle? Better print quality than the 0.4mm nozzle standard even though print time increases significantly and clogging resistance takes a hit. The 0.2mm nozzle also works with PETG. I read up on using PP filament with Bambu Lab printer (I've assumed at this point...