Recent content by Robaba89

After finishing a bowl and dumping it- hit through it it again, just the screen. Then follow up with another quick scrape. This will keep it clean a lot longer!

Quick question.. I seem to remember someone saying it was dangerous to use 3.7v li.ion batteries if the label has been torn. Can I get some more info? One of the labels on my AW IMR's got partially ripped by the charger. From the bottom, almost all the way to the top. Its an eighth of an inch...

Trust me, it's a 5ohm. I've ran it through 3+G of oil on 7.4, and had it on double top with another printed 5ohm and they were equal :) The 2 un-marked 5ohms came with my unit from PV back at release.. along with the blue, fucked up, long 3.7v. Probably a limited production cart lol.

So... odd thing.. One of my first five ohm carts(no label print) must have lost something. I can see all the way through the cart. It's still working.. and not leaking yet... It's airflow is actually fantastic haha. Dunno if I'll fill it a fifth time.. But the main reason for this post is...

I would "Micro hit" ala mflb to get bigger hits off the 2.4 carts. Depending on the viscosity of your extract, you should hold the button down for a few sec before you even start drawing.

I appreciate the tips, but I don't have a clog. The cart that leaked is clean now... I had assumed that it would leak again if I refilled it.... it didn't leak prior to the blow-drying heat up.. and I have other functional carts. If this one is going to be a problem I don't want to use it. If...

Dunno? I thought that I may have melted one of the seals, which is why all that oil leaked out the bottom. If the cart is still good, then it's a keeper. Not sure what you meant by "go .4 at a time", but I usually load .5~.7g at a time..

So I used this method on a cart that was having the same issue- the wax on this load was not wicking. It totally got the wax to flow, but it flowed just a bit too well. 0.2 or so came out of the bottom air-hole lol. Cart still wasn't too hot to touch. Wouldn't say over 125~130º. I'd say only...

I still have a hard time with battery terms, so if you could be more specific? The IMR 18350s? And we'd need two? These are different than the trustfires that shipped with the persei a while back?

just got a cup-nail and dome set.. gona try dropping the hammer when it arrives :)

^Bahahahahahahah That was the best laugh I've had in a while. The read, followed by the pic is just priceless hahaha. I've been hitting 3ohm @ 7.4+v on the persei for a bit now. Yes, the vapor production is very responsive to the button. I literally tap it and get generous hits. It's easy to...

I've been doing some playing around with my 3ohm cart @7.4v fully charged. Me like. It's vaped off about .7g so far. I've used it a few other times this week too.. wonder how long till it pops... But hell, after a bit over a month of full use.. I love the single 5ohm at 7.4v, and the...

Just hit the "reply" tab on the bottom right of their post. Next to the "like" button. Double topped myself into oblivion last night. Fell asleep at 6:30...

Wake up, medicate, try to eat.

Gotta think of how it would sound when you refer to it... "Did you pick up the _____ for your persei?" moderari (latin;regulate) adaptulator.. anvil (we have the hammer and nail) To go along with everyone else picking a name that means something; Sophrosyne was the goddess of moderation and...